Trailer with working platform

MÜLLER-MITTELTAL T4, Luftfed., hydr. Klapprampe, Baggerstiel.

Condition: new, maximum load weight: 30,740 kg, overall weight: 40,000 kg, axle configuration: > 3 axles, Year of construction: 2026, * T 4: * Wabco EBS-E (electronic braking system) * RDÜ tire pressure monitoring system * Emergency release device for spring brake cylinders * Drum brakes * 4 x 11 t Gigant axles * Air suspension with lift/lower system and RtR valve * Smard board for payload weight determination * Warning sign packages front & rear * Reflective contour tape on the sides and rear * Rear removable beacon light * LED lighting * Straight drawbar with 50 mm towing eye and continuously variable height adjustment * Tool box made of powder-coated sheet steel and spare wheel holder in basket design, fitted on the right side * Front closed single fender made of plastic * Rear straight steel mudguard aprons, each with spray protection (spray suppression) * Side underrun protection * Turntable platform extended by 520 mm with 45° corners and three integrated storage compartments incl. lids, lockable * Chassis made of high-strength fine-grain steel * Flooring above turntable platform made of 50 mm and in low-bed platform of 60 mm softwood * Outer planks of access ramps made of hardwood * 4 stake pockets per side (stakes not included), each with 2 t lashing point * Lashing package consisting of: 2 lashing eyes 6.4 t at the front left and right on the main frame of the turntable platform * On each side front and rear: 2 pairs of 13.4 t lashing rings on the outer frame, and 4 pairs of 10 t lashing rings per side, swiveling and retractable * Loadable in all directions and recessed into the outer frame * 2 pairs of 6.4 t lashing rings in the excavator arm recess * 8 pairs of galvanized folding outriggers for 3 m total width (except for the rear slope) * Widening planks stored in a box on the left side * Excavator arm recess above the rear axle up to the start of the ramp incline: approx. 2,100 x 740 x 190 mm * Mechanical support legs at rear * Hydraulic folding ramps with hydraulically extendable tip section approx. 4,650 x 720 mm incl. hydraulic ramp lateral shift & load holding valve Dsdpfx Aol Tphrefmecp * Load area above turntable: approx. 2,990 x 2,520 mm * Rear loading area: approx. 6,780 x 2,520 mm * Loaded deck height: approx. 890 mm, +/- 20 mm (incl. 860 mm ramp incline) * Flow divider installed * Chassis, turntable, access ramps, folding outriggers, and mechanical support legs hot-dip galvanized * Axles, drawbar, air tanks and turntable painted in black * Tires: 235/75 R 17.5 * New vehicle without initial registration with manufacturer’s warranty * Errors and prior sale reserved * Available from CW 07/2026