Tipper semitrailer

FLIEGL

Chassis: Semi-Tipper
Iedpfjyu Rllex Adwjap
Fine-grain steel welded construction, in Basic lightweight design, fifth wheel plate with replaceable 2" kingpin
Curved front bulkhead
Telescopic landing leg in the middle, uncoupling not possible when loaded
Wheel chocks with holder
Underrun protection, foldable
Underrun protection with "spring assist" for easier operation
Half-shell mudguards
Tarp pole with holder
Tow hook at rear

Axles & Suspension
BPW disc brake axles with 430 mm disc diameter
Axles/chassis laser measured
1st axle is an automatic lift axle, additionally electrically controllable from the truck, including forced lowering and starting aid, does not require truck installation

Brake System
2-line compressed air brake system
Spring-applied parking brake
2 interchangeable coupling heads at the front, without connecting line
24 volt EBS, electronic braking system with EBS socket at the front, without connection cable
Automatic tipping lowering with shut-off valve
Trailer Info Module for displaying vehicle data such as axle loads (not calibrated), mileage, and diagnostic/system messages.
Axle load detection via EBS-CAN bus signal

Wheels and Tires
385/65 R22.5
Polished aluminum rims

Electrics
24 volt, multi-chamber lights, LED side marker lights (yellow)
2 white LED position lights at the front
2 white/red lane marker lights at the rear
2x 7-pin and 1x 15-pin interchangeable sockets at the front

Hydraulics
High-pressure cylinder max. 250 bar, lower stage hard-chromed, with HDK screw coupling, fixed part, no hose connection

Body
Steel round body in "Stone Master Design" made from highly wear-resistant HB400/450 steel. Sloped front wall with external mounting for hydraulic cylinder
Internal ladder at the front wall
Shovel and broom holder externally on the front wall
Rear wall as swinging tailgate, externally mounted with double hook lock. 2 clamping screws with toggle catches on the lower sides.
"Spacer for swinging tailgate" can be hooked into the clamping screws
Side walls continuously 4 mm thick, floor 4/5 mm thick, wear- and weight-optimized design
Fliegl S.T.E.P. – pivoting front standing platform with foldable access ladder for access on front-left, only in combination with "Flip Top sliding cover"
Body in insulated version, Fliegl Asphalt Profi Thermo, body insulated at the front, sides, bottom, and rear with Fliegl Isotherm metal cladding
"Flip Top sliding cover", automatic rear closure as folding hoop. Cover is mounted towards the front. Electrically operated cover, with 7-pin plug (charging socket at the front, without connection cable, including tractor socket loose, no truck installation, operation on the trailer and via remote control)
Connection cable 7-pin to truck as spiral cable for sliding cover, a socket must be installed on the truck

Operating Notes
For transports of salt, lime, etc., we recommend a tipping cylinder with a hard-chromed piston rod to prevent corrosion from the material.
The stated gross weight is technically feasible, but depending on the load, the maximum gross weight may not be achievable within permissible axle/support/kingpin loads. Note: Not suitable for chemically aggressive media (e.g. acids, chlorine compounds, sulfur compounds, alternative fuels); vehicles with loading bodies are only intended for non-aggressive chemical loads.

Paintwork
Frame: DB 7350 nova grey
Support legs: galvanized
Body: RAL 5002 ultramarine blue
Roll tarp: RAL 5002 ultramarine blue

The listing was translated automatically. Translation errors are possible.