Semi-trailer containerchassis

Fliegl SDS 380 für 20 Fuß light mit 725 mm Überhang

Customized Transport Solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are carried out individually according to customer requirements.

Chassis, Saddle, Container
Fine-grained steel welded construction, saddle plate with 2 interchangeable kingpins
Container receptacles:
1 x 20 ft in the center (or swap body container 7.15 / 7.45), not retractable at the front, the pivot pins of the container locking mechanism in the longer version
24 tons, 2-stage support jacks, single-sided operation
with anti-splash flaps according to EC
Front axle drip tray with 1 1/4 inch drain pipe + 1 1/4 inch shut-off valve, incl. drip tray, with perforated tread plates, approx. 400 mm wide, left + right between the drip tray and the longitudinal beam
4 hose racks, approx. 4500 mm long, for hose pipes 2 x DN 200 on the outside + 2 x DN 160 arranged in the center, hose box (stainless steel) at the rear, 300 mm deep, splash-proof, lid (stainless steel) all around with rubber seal, with drain hole at the lowest point, then without lid on the hose pipes
1 stainless steel grounding lug at the rear on the right on the frame, with international grounding sticker on the frame
Climbing steps at the rear right on the underrun protection, at the rear on the right outside on the main beam, tread plate approx. 260 mm long and 300 mm wide
Axles + Suspension
SAF disc brake axles
Axle/chassis laser-measured to reduce tire wear and fuel consumption
Offset axle spacing (combined transport) up to 44 tons total weight
Air suspension
1st axle automatic lift axle, including forced lowering and starting aid, actuation 3x brakes
Braking system
2-line pneumatic braking system
Color-coded line routing for easy maintenance
Spring-loaded parking brake
2 fail-safe coupling heads at the front, without connecting line
EBS, Electronic Braking System with EBS socket at the front, without connecting cable
Note: The trailer may only be pulled by tractor units that guarantee the effectiveness of the ABS!
with lifting and lowering valve
Vehicle - Driving Stability System
Axle load detection via EBS-CAN bus signal, for display on the screen in the driver's cab, truck must be prepared accordingly, no truck installation (no calibrated scale)
Wheels and Tires
385/65 R22.5, manufacturer's choice
Gedpfoi Rixksx Agusuc
Steel rims, factory silver
Electrical System
24 Volt, multi-chamber lights, yellow LED lighting on the side
2 white position lights at the front
2 white/red side marker lights at the rear
1 x 15-pole socket at the front, without connecting cable
Operating Instructions
The specified total weight is technically possible; depending on the cargo, the total weight may not be reached while complying with the permissible axle/support and saddle loads. (Poor driving and handling behavior possible due to incorrect load distribution)
This vehicle may only be loaded with 20' tank containers that comply with ISO 668 and in particular ISO 1496-3! The tank containers must have "end-load-transfer areas" ("end-crossmember-load-transfer areas")!
Country of Approval/Signs
Germany
Type approval according to EC 2007/46
24/7 service hotline
prepared for single-line license plate holder
Warning sign according to ECE - 70
Acceptance according to ADR according to 9.1.1.2 of the ADR, EX/II, EX/III / Registration certificate for vehicles for the transport of certain dangerous goods (ex.B3) with warning sign on the rear, not valid for substances according to UN

The listing was translated automatically. Translation errors are possible.