Open semitrailer with tarp

FLIEGL Fliegl SZS 270 Mega Plateau Auflieger

Attention: The images are archive photos! The vehicle may currently be in use!

Weights and Dimensions:
Gjdpsy Sk Rqjfx Ap Heub
Gross vehicle weight: 27,000 kg
Payload approx.: 22,200 kg
Axle load: 16,000 kg
Stated fifth wheel load: 11,000 kg
Unladen weight approx.: 4,800 kg +/- build tolerance

Overall length approx.: 13,850 mm
Overall width max.: 2,550 mm
Overall height approx.: 2,245 mm
Platform length approx.: 13,650 mm
Platform width approx.: 2,480 mm
Fifth wheel height approx.: 950 mm
King pin installation dimension approx.: 1,680 mm
Front corner dimension approx.: 2,040 mm

Chassis Semi-Trailer Forwarder
Fine-grain steel welded construction, mounting plate with replaceable 2" king pin
13 pairs of lashing rings recessed in outer frame, each rated 2.5 t
Outer frame with “Load-Lock profile” for securing straps
24 t two-speed landing gear, single side operation, with flat base plate, without compensating slide
Chocks with holder
Aluminum side underrun protection
Steel rear underrun protection
Quarter-shell mudguards
Document box on front wall, left-hand side (mounted slightly sloped)

Axles & Suspension
BPW disc brake axles
Air suspension

Braking System
2-line compressed air brake system
Spring-loaded parking brake
2 non-interchangeable coupling heads at front, no connecting line
EBS, Electronic Braking System, with EBS socket at front, without connecting cable
Attention: The trailer may only be towed by tractor units equipped with functional ABS!
With lift and lower valve
Vehicle Stability Control System

Wheels and Tyres
385/55 R19.5” – make at manufacturer’s discretion
Steel rims, factory silver

Electrics
24 Volt; multicompartment rear lights (3 sets of older Hella lights still available at plant for optional installation); lateral yellow LED markers recessed as far as possible
2 white front position lamps, each protected by 12 mm round bar welded over the top
2 white/red lane marker lights at rear
2 x 7-pin non-interchangeable sockets at front, without connecting cables

Floor
Approximately 30 mm phenolic plywood, cross joints with Omega insert, laid on longitudinal supports for high point-load capacity, suitable for forklift axle load up to max. 7,100 kg
Note: Floor warping due to weather exposure possible!

Front bulkhead / Corner posts
Approx. 1,200 mm high, corner posts made of volumetric steel

Approval / Plates
Country of registration: Germany
With Dekra inspection and report
24/7 service hotline
Prepared for single-line license plate holder
Warning panel according to ECE-70
Contour marking with reflective strips in accordance with ECE R 048, white (sides) and red (rear)

Paintwork
Chassis: RAL 3002 carmine red
Landing legs: Black coated
Front bulkhead: RAL 3002 carmine red

Attention: The images are archive photos! The vehicle may currently be in use!

The listing was translated automatically. Translation errors are possible.