Tipper trailer

Blomenröhr 896/14000 14 t Tandem 2 Seiten Kipper Tieflader

Condition: new, machine/vehicle number: ebf3f771e96394cd89e56bbb7, overall weight: 11,800 kg, axle configuration: 2 axles, tire size: 235 / 75 r 17,5, Further information Chassis central axle trailer Welded fine-grained steel construction 6 pairs of lashing eyes bolted to the outside of the floor/outer frame, 5 tons each 2 pairs of lashing eyes additionally bolted to the floor, 5 tons each in the corners Gear support foot at the front Folding rear support 2 wheel chocks with holder Steel underride guard Rear spray flaps across the entire width Quarter-shell mudguards 1 plastic tool box, with shelf, w=620/h=360/t=440 mm, lockable with a padlock. (lock not included in scope of delivery) Towing device central axle trailer Hfjdsi Rixrjpfx Aa Ssf Towing bar with tested 40 mm towing eye Height-adjustable drawbar via spindle, max. adjustment range 300 mm Axles + suspension Drum brake axles, manufacturer's choice Axle/chassis laser-measured Reduction in tire wear and fuel consumption Parabolic suspension with maintenance-free steel-rubber bearings and mechanical axle load compensation (rocker compensation) Wheels and tires 235 / 75 R 17,5 manufacturer's choice Factory silver steel rims Brake system 2-line compressed air brake system Hand spindle parking brake Integral air reservoir 2 non-interchangeable coupling heads at the front, with connecting cables to the motor vehicle, ABS and ALB, with ABS plug at the front, with connecting cable Electrical system 24 volt, multi-chamber lights, amber LED lighting at the side 2 white position lights at the front 2 white/red lane departure lights at the rear 2 x 7-pin interchangeable plugs at the front, with connecting cable, Floor Steel/ checker plate floor for high point load capacity Note: Slight floor corrugation possible due to welding distortion! Platform length approx. 5,200 mm Rear sloping to approx. 900 mm Front wall / front corner stanchions 25 mm aluminum hollow profile, 400 mm high, Drop sides 25 mm aluminum hollow profile, 400 mm high, foldable and removable Rear wall / rear corner stanchions 1 pair of steel stanchions attached to the frame and with bracket for locking the drive-on ramps, drive-in width approx. 2,430 mm Drive-on ramps 2 steel ramps 2,300 mm long, 510 mm wide, can be moved sidewayswith grab handle on the ramps covered with 3 toothed steel rails With gas pressure jack for one-man operation Country of registration/plates Country of registration: Germany 24/7 service hotline Prepared for single-line license plate holder Contour marking with reflective strips in accordance with ECE R 048, white on the sides and red on the rear Paintwork Hot-dip galvanized frame incl. passivation 15-year warranty against rusting through Front wall aluminum Side wall anodized aluminium Drive-on ramps Hot-dip galvanized Attention! These are archive pictures.

Condition: used, tire size: -, Year of construction: 2016, operating hours: 440 h, Equipment: cabin, Ref: 8088 Morain coupler + 3 buckets Hydraulic line Hfsdpfx Aow Td Hmja Sjf Hydraulically adjustable track width from 0.70 to 0.90 m Blade 0.70 m with extension for 0.90 m Delivery time (in days): 1

Condition: used, machine/vehicle number: Gebrauchter Anhänger, empty load weight: 2,422 kg, maximum load weight: 7,568 kg, overall weight: 9,990 kg, axle configuration: 2 axles, first registration: 05/2020, next inspection (TÜV): 05/2021, loading space length: 5,000 mm, loading space width: 2,010 mm, loading space height: 250 mm, loading space volume: 2.5 m³, suspension: steel, Year of construction: 2022, Used trailer, TOP condition TÜV NEW You can rent these trailers !!! \Price per day : 135.- \Price for 3 days 370.- Euro \Weekly price 670.- Euro \All prices incl. 19 % VAT. Hedpfx Aed U A S Eja Ssff \

Condition: used, maximum load weight: 8,900 kg, overall weight: 11,900 kg, axle configuration: 2 axles, first registration: 01/2013, loading space length: 6,100 mm, loading space width: 2,000 mm, loading space height: 400 mm, * Demmler TT 119 tandem low-loader trailer for milling transport * EZ 2013 * Support for conveyor belt * Air suspension Hedpfx Ajt Ux Dboa Seff * Adjustable drawbar * 3 ramps * Payload 8900 kg * LGW: 3000 kg * GGW: 11900 kg * Platform dimensions: 6.10 m x 2.0 m x 0.40 m * Loading height 70 cm * Ramp length: 2.50 m

Condition: new, machine/vehicle number: dd98a7658922be8f2e25bcadb, empty load weight: 2 kg, maximum load weight: 8 kg, overall weight: 10 kg, axle configuration: 2 axles, tire size: 235/75 r 17,5, Further information Chassis central axle trailer low bed Fine-grained steel welded construction Telescopic front support leg Telescopic rear support 2 wheel chocks with holder Mudguards made of sheet steel over both wheels Towing device central axle trailer Tow bar with tested 40 mm towing eye Height-adjustable drawbar via spindle, max. adjustment range 250 mm Axles + suspension Euro axles of our choice, with angular roller bearings and S-cam brake Axle/chassis laser-measured Reduction in tire wear and fuel consumption Parabolic suspension with maintenance-free steel-rubber bearings and mechanical axle load compensation (rocker compensation) Wheels and tires 235 / 75 R 17,5 manufacturer's choice Factory silver steel rims Brake system 2-line compressed air brake system Spring-applied parking brake 2 interchangeable clutch heads at the front, with connecting cables to the motor vehicle, ABS and ALB, with ABS plug at the front, with connecting cable Hfodpfji Ri Ebjx Aa Sof Attention: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS! Electrical system 24 volt, multi-chamber lights, amber LED lighting at the side 2 white position lights at the front 2 white/red lane departure lights at the rear 2 x 7-pin interchangeable plugs at the front, with connecting cable, TTS bridge Low-lying steel trough, bridge floor made of steel/checker plate covering, steel walls solidly welded to floor Bridge length 4500 mmTub at the front and sides with Load-Lock profile for attaching tensioning straps (8 straps at the front, 12 straps on each side) Note: Slight floor undulation possible due to welding distortion! 2 pairs of lashing eyes, 1 x at the front in the corners of the steel tray and 1 x at the rear in the floor, 5 tons each. 2 additional pairs of lashing eyes in the floor, 5 tons each Drive-on ramps Steel ramps 2 300 mm long, 510 mm wide, can be moved sideways with grab handle on the ramps covered with wood With gas pressure jack for one-man operation Operating instructions The specified total weight is technically possible; depending on the load, the total weight may not be reached if the permissible axle/support and fifth-wheel loads are observed. (Poor driving and trailing behavior possible due to incorrect load distribution) Country of registration / plates Country of registration: Germany with Dekra approval and expert opinion (according to §13 EG - FGV) 24/7 service hotline Prepared for single-line license plate holder Contour marking with reflective strips in accordance with ECE R 048, white at the sides and red at the rear Paint finish Frame RAL 3002 carmine red Hot-dip galvanized drive-on ramps Attention: Archive pictures!

Condition: new, maximum load weight: 5,600 kg, overall weight: 7,500 kg, axle configuration: 2 axles, loading space length: 4,500 mm, loading space width: 2,000 mm, loading space height: 330 mm, Year of construction: 2024, Equipment: ABS, * Drum brakes * Ramps spring-supported & can be moved sideways Hfedomw U Abopfx Aa Sof * Frame completely hot-dip galvanized * 18 lashing rings recessed in the bridge floor * Loading height approx. 630 mm * Height-adjustable tow arm * Trailer available immediately * Suspension: leaf * Payload: 5,600 kg * Tires: 215/75R17.5 ----Information non-binding - errors not excluded - sale reserved

Condition: new, empty load weight: 3,650 kg, maximum load weight: 10,750 kg, overall weight: 14,400 kg, axle configuration: 2 axles, loading space length: 5,120 mm, loading space width: 2,420 mm, suspension: steel, tire size: 385/55 R 19,5, color: other, gearing type: other, front tire size: 385/55 R 19,5, rear tire size: 385/55 R 19,5, driver cabin: other, emission class: none, fuel: biodiesel, Equipment: ABS, compressed air brake, Three-way tipper, side walls 600 mm high, galvanized, loading height approx. 990 mm, 4 x lashing eyes in the floor, 5 tonnes each, 8 x lashing eyes in the floor, 3 tonnes each, reinforced geared support winch with load and fast gear at the front, ?Wide tires: 385/55 R 19.5, Chassis: hot-dip galvanized, , Surcharge for:, aluminum ramps (approx. 3520 x 400 mm), load capacity per pair 10 tonnes and 2 folding supports at the rear, Price: 1500 Euro,   , , --  Subject to printing errors, errors and changes, Sample images --, More details at: !, More details: ! Hfjdsyz Tvhjpfx Aa Sef

Condition: used, first registration: 06/2015, overall weight: 11,800 kg, empty load weight: 2,920 kg, color: other, axle configuration: 2 axles, gearing type: other, emission class: none, maximum load weight: 8,880 kg, suspension: steel, tire size: 235/75 R17,5 143J, front tire size: 235/75 R17,5 143J, rear tire size: 235/75 R17,5 143J, driver cabin: other, wheelbase: 990 mm, Equipment: ABS, compressed air brake, , -- Misprints, errors and omissions excepted, sample pictures --, More details under: !, More Details: ! Hfedpsyy Urzefx Aa Ssf

Condition: used, empty load weight: 3,380 kg, maximum load weight: 10,120 kg, overall weight: 13,500 kg, axle configuration: 2 axles, first registration: 05/2012, loading space length: 6,350 mm, loading space width: 2,480 mm, suspension: steel, color: other, gearing type: other, driver cabin: other, emission class: none, Equipment: ABS, compressed air brake, 400 mm drop sides, front for through-loading, 4 x lashing eyes, 18 x lashing eyes, wooden floor def., , Sale is via customer, , -- Misprints, errors and omissions excepted, sample pictures --, More data under: !, More Details: ! Hfsdpfxeyyzhpj Aa Sjf

Condition: used, machine/vehicle number: WFDFLT21001012243, empty load weight: 2,500 kg, maximum load weight: 8,000 kg, overall weight: 10,500 kg, axle configuration: 2 axles, first registration: 07/2022, tire size: 235/75 r17,5, Year of construction: 2022, Further information Chassis central axle trailer low bed Welded fine-grained steel construction, front gear support foot, telescopic rear support, wheel chocks with bracket, sheet steel mudguards over both wheels Towing device central axle trailer Drawbar with tested 40 mm towing eye, height-adjustable drawbar via spindle, max. adjustment range 250 mm Axles + suspension Euro axles of our choice, with angular roller bearings and S-cam brakes, laser-measured axle/chassis to reduce tire wear and fuel consumption, parabolic suspension with maintenance-free steel/rubber bearings and mechanical axle load compensation (rocker compensation) Brake system 2-line compressed air brake system, spring-loaded parking brake, 2 interchangeable coupling heads at the front, with connecting lines to the motor vehicle, ABS and ALB, with ABS plug at the front, with connecting cable Attention: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS! Electrical system 24 volt, multi-chamber lights, amber LED lighting at the side, 2 white position lights at the front, 2 white/red lane departure warning lights at the rear, 1 x 15-pin plug at the front, with connecting cable, TTS bridge low-lying steel trough, bridge floor made of steel/checker plate covering, steel walls solidly welded to floor, bridge length 5500 mm, trough at front and sides with load-lock profile for tensioning strap attachment (8 pieces at front, 16 pieces on each side) Note: Slight floor undulation possible due to welding distortion! Pair of lashing eyes, 1 x at the front in the corners of the steel tray and 1 x at the rear in the floor, 5 tons each. Pair of additional lashing eyes in the floor, 5 tons each Drive-on ramps Steel ramps 2 300 mm long, 510 mm wide, can be moved sideways, with handle on the ramps, covered with wood, with gas pressure jack for one-man operation Operating instructions The specified total weight is technically possible; depending on the load, the total weight may not be reached if the permissible axle/support and fifth-wheel loads are observed. (Poor driving and trailing behavior possible due to incorrect load distribution) Country of registration / plates Country of registration: Germany, with Dekra approval and expert opinion (in accordance with §13 EG - FGV), prepared for single-line license plate holder, contour marking with reflective strips in accordance with ECE R 048, white at the sides and red at the rear Hfsdpfx Aoqmc Raja Sef