Trailer with working platform

MÜLLER-MITTELTAL 5 achs Tieflader, Nachlauflenkachse, MA liftbar

Condition: new, overall weight: 50,000 kg, maximum load weight: 38,900 kg, axle configuration: > 3 axles, Year of construction: 2025, * T5 Profile 50.0: * Wabco EBS (Electronic Braking System) * TPMS (Tire Pressure Monitoring System) * Emergency release device for spring brake cylinders * Drum brakes * 4 x 11 t Gigant axles * Last axle with self-steering (locking the trailing axle for maneuvering purposes possible from the cab without the need for truck-side installation, and additionally via a switch on the trailer); lock must be disengaged before entering public roads * Air suspension, lifting and lowering system with RtR valve * 3rd axle liftable (ride height +30 mm when lifted) * Forced relief and forced lowering of the lift axle for maneuvering purposes (requires truck-side installation) with speed-dependent switching via EBS electronics * Smartboard as infotool with pressure sensors to display total axle load per axle group * Tire pressure monitoring with display option in the truck via EBS signal (no truck-side installation required) * Mechanical signboard package for 3 m overall width * Drawbar 1,500 mm long with 50 mm draw eye and manual height adjustment * LED lighting system 12 / 24 V * Removable LED beacon at rear * Toolbox made of galvanized sheet steel approx. 650 x 300 x 600 mm, mounted left side * Plastic front mudguards and galvanized steel rear mudguard aprons * Turntable platform with 45° corners and 3 storage compartments with lockable hinged lids (hinges open to the rear) * Reduction of low-loader platform by 500 mm to 6,280 mm including extended offset bend by 500 mm to the front * Load securing package: 2 x 6.4 t lashing eyes at the front corners, 2 x 13.4 t UVV lashing eyes at each front and rear side corner, 5 x 10 t UVV lashing rings on each side (swiveling and lowerable, loadable in all directions), 4 stake pockets per side with 2 t lashing option, 1 x 16 t UVV lashing eye at rear cross member * Rubber covering on the folding ramp, approach slope, and on the running surface of the low-loader platform * Bamboo wood filler between side members before excavator stick support * Extendable and folding outriggers for 3 m total width (plank holders under chassis, right side) * Continuous excavator stick support with reinforcement profile from last axle to rear crossmember approx. L=2,350 x W=770 x H=270 mm, 2 pairs of 6.4 t UVV lashing rings on sides of the excavator stick support * Hydraulic folding ramp with dual-circuit hydraulics and deployable tip section approx. 4,650 x 720 mm incl. load-holding valves and hydraulic side-shift * Hydraulic rear support * Hydraulic flow divider (for truck hydraulic pump output over 40 l/min up to max. 140 l/min) * Loaded deck height 890 mm +/- 20 mm due to air suspension * Deck above turntable: 2,600 + 390 x 2,520 mm * Low-bed loading area: 6,280 + 500 x 2,520 mm, incl. 860 mm approach slope * Chassis, turntable, drawbar, extension consoles, and access ramps hot-dip galvanized * Drawbar, axles, hydraulic axle supports, and air tanks painted in black tone * New vehicle with manufacturer's warranty * Errors and prior sale excepted Kodpfx Abel Tihuelodu * Available from week 14/2026